4th Clutch Piston Installation
WARNING: This page is about a different variant/trim than selected.
| Callout | Component Name |
|---|---|
| 1 | 4th Clutch Piston Tip: Use a 2 inch spacer between DT-48056 and DT-47694 . See Special Tools . Special Tools
|
| 2 | 4th Clutch Piston Retaining Spring Assembly |
| 3 | 4th Clutch Piston Retaining Ring Tip: Do not reuse the retaining ring. |
| 4 | 4th Clutch Waved Plate |
| 5 | 4th Clutch Plate Tip: Alternate between steel and fiber clutch plates. |
| 6 | 4th Clutch Plate Assembly Tip: Alternate between steel and fiber clutch plates. |
| 7 | 4th Clutch Backing Plate |
| 8 | 4th Clutch Piston Retaining Ring Tip: Do not reuse the retaining ring. |