LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Hybrid Engine Electrical System (Hp2)) >> Diagnostic Information and Procedures >> DTC C0900 or C12E2 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Engine running, accessories OFF, measure and record the battery voltage at the 12 V battery terminals. The voltage should be between 12.6-15.0 V.
  2. Observe the scan tool EBCM Battery Voltage parameter. The reading should be between 12.6-15.0 Volts.
    • If greater than the specified range, replace the EBCM.
scientia non olet · About LEMON Manuals