LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Hybrid Engine Electrical System (Hp2)) >> Diagnostic Information and Procedures >> DTC C0895 (ESC) >> Circuit/System Testing (ESC)

Circuit/System Testing (ESC)

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector of the ESC module.
  2. Ignition OFF and scan tool disconnected, open and close the driver door, and wait 1 minute. Test for less than 5 ohms between the ground circuit terminal 47 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Verify that a test lamp illuminates between the 12V B+ circuit terminal 32 of the ESC module and ground.
    • If the test lamp does not illuminate, test the 12V B+ circuit for a short to ground or an open/high resistance.
  4. If all circuits test normal, replace the ESC module.
scientia non olet · About LEMON Manuals