LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Hybrid Engine Electrical System (Hp2)) >> Diagnostic Information and Procedures >> Battery Charging >> Charging Procedure

Charging Procedure

WARNING: This page is about a different variant/trim than selected.
WARNING: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

Use the following procedure to charge the battery:

  1. Turn OFF the charger.
  2. Ensure that all of the 12V battery terminal connections are clean and tight.
  3. Connect the charger positive lead to the battery positive terminal on the battery.
    4. CAUTION: Do not connect the negative charger lead to the housings of other vehicle electrical accessories or equipment. The action of the battery charger may damage such equipment.
  4. Connect the negative charger lead to a solid engine ground in the engine compartment. If the negative battery cable is disconnected, connect directly to the battery.
  5. Turn ON the charger and set to the highest setting for normal charging.
  6. Inspect the battery every half hour after starting the battery charger.
    • Charge the battery until the taper-rate charger indicates that the battery is fully charged.
    • Estimate the battery temperature by feeling the side of the battery. If it feels hot to the touch or its temperature is over 45°C (125°F), discontinue charging and allow the battery to cool before resuming charging.
  7. After charging, test the 12V battery. Refer to Battery Inspection/Test .
scientia non olet · About LEMON Manuals