LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: When reusing valve lifters, install the lifters to their original locations.
    Fig 1: Exploded View Of Lifter Guides & Lifters
    GM1402040Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the valve lifters (209) and engine block valve lifter bores with clean engine oil.
  2. Insert the valve lifters into the lifter guides (210). Align the flat area on the top of the lifter with the flat area in the lifter guide bore. Push the lifter completely into the guide bore.
    3. Fig 2: View Of Lifter Guides & Lifters
    GM1402039Courtesy of GENERAL MOTORS CORP.
  3. Install the valve lifters and guide (210) to the engine block.
    4. CAUTION: Refer to Fastener Caution .
  4. Install the valve lifter guide bolts.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  5. Install the cylinder head and gasket. Refer to Cylinder Head Replacement - Left Side  or Cylinder Head Replacement - Right Side .
scientia non olet · About LEMON Manuals