LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Valve Lifter Oil Manifold Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
NOTE: All gasket surfaces should be free of oil or other foreign material during assembly.
    Fig 1: Identifying Valve Cover Outer Gasket
    GM1509593Courtesy of GENERAL MOTORS CORP.
  1. Place the service gasket (1) onto the valve lifter oil manifold.
    2. Fig 2: Valve Lifter Oil Manifold
    GM1509591Courtesy of GENERAL MOTORS CORP.
  2. Install the valve lifter oil manifold (1) to the engine.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the valve lifter oil manifold bolts (2).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 3: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp
    GM1697098Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine harness electrical connector (1) to the oil pressure sensor.
  5. Install the intake manifold. Refer to Intake Manifold Replacement .
scientia non olet · About LEMON Manuals