LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - On Vehicle >> Engine Oil Level Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Oil Level Sensor
    GM260123Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the oil level sensor to the oil pan.

    Tighten:  Tighten the sensor to 20 N.m (15 lb ft).

    2. Fig 2: Identifying Engine Harness Electrical Connector & Oil Level Sensor
    GM1968647Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine harness electrical connector (1) to the oil level sensor.
    3. Fig 3: View Of Oil Pan Drain Plug & Seal
    GM1658109Courtesy of GENERAL MOTORS CORP.
  3. Ensure that the oil pan drain plug is tight.

    Tighten:  Tighten the drain plug (430) to 25 N.m (18 lb ft).

  4. Lower the vehicle.
  5. Fill the engine with NEW engine oil. Refer to Fluid and Lubricant Recommendations and Approximate Fluid Capacities .
  6. Start the engine and inspect for leaks.
scientia non olet · About LEMON Manuals