LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - Off Vehicle >> Intake Manifold Cleaning and Inspection >> Cleaning Procedure

Cleaning Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake Manifold-To-Cylinder Head Gasket
    GM1277097Courtesy of GENERAL MOTORS CORP.
  1. Remove and discard the intake manifold-to-cylinder head gaskets (514).
    2. Fig 2: Intake Manifold
    GM1401989Courtesy of GENERAL MOTORS CORP.
  2. Remove the manifold absolute pressure (MAP) sensor (714). Refer to Intake Manifold Removal .
  3. Remove the evaporative emission (EVAP) canister purge solenoid valve, EVAP tubes, and fuel rail with injectors. Refer to Fuel Rail and Injectors Removal .
  4. Remove the throttle body and gasket. Refer to Throttle Body Removal .
  5. Clean the intake manifold (500) in solvent.
    6. WARNING: Refer to Safety Glasses and Compressed Air Warning .
  6. Dry the intake manifold with compressed air.
scientia non olet · About LEMON Manuals