LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Engine Mechanical - Hybrid (Hp2) 6.0L (LFA)) >> Repair Instructions - Off Vehicle >> Engine Coolant Air Bleed Pipe and Hole Cover Installation

Engine Coolant Air Bleed Pipe and Hole Cover Installation

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
    NOTE: Position the O-ring seal onto the nipple portion of the pipe.
  1. Install the seals (308) onto the engine coolant air bleed pipe and covers.
    2. Fig 2: Engine Coolant Air Bleed Pipe
    GM1401993Courtesy of GENERAL MOTORS CORP.
  2. Install the pipe (307) and seals (308).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the bolts (309) and tighten to 12 N.m (106 lb in).
    4. Fig 3: Engine Coolant Air Bleed Cover Bolts
    GM1402001Courtesy of GENERAL MOTORS CORP.
  4. Install the covers (313) and seals (308).
  5. Install the bolts (312 and tighten to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals