Measuring the Cylinder for Oversize
WARNING: This page is about a different variant/trim than selected.
- Adjust the micrometer to a dimension slightly smaller than the bore size. Refer to Engine Mechanical Specifications .
- Insert the J 8087: gage into the micrometer and zero the bore gage dial.
- Use the J 8087:
gage and measure the cylinder bore for oversize.
Slide the bore gage up and down throughout the length of the cylinder bore. Measure the bore, both parallel and perpendicular to the centerline of the crankshaft, at the top, center, and bottom of the bore. A cylinder bore that exceeds the maximum diameter must be serviced with an oversized piston. Refer to Engine Mechanical Specifications .