Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Engine running, command the affected cylinder deactivation solenoid ON and OFF with a scan tool while observing the following cylinder deactivation control circuit status parameters:
- Cylinder 1, 4, 6, or 7 Solenoid Control Ckt. Short Gnd Test Status
- Cylinder 1, 4, 6, or 7 Solenoid Control Ckt. Open Test Status
- Cylinder 1, 4, 6, or 7 Solenoid Control Ckt. Short Volts Test Status
Each parameter should toggle between OK and Not Run or Not Run and OK
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.