LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P1255 To DTC P3449) >> DTC P3400 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Start and idle the engine.
  2. Allow the engine to reach normal engine operating temperature. The engine should idle smoothly, without any misfires. If the engine misfires, refer to DTC P0300-P0308 .
  3. Monitor the cylinder deactivation system data parameters with a scan tool.
  4. Road test the vehicle under light throttle and load conditions that will allow the engine to command V4 mode. If all enabling conditions are met for cylinder deactivation, and if no internal engine hydraulic/mechanical fault conditions are present, the ECM will continue with V4 mode operation.
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals