Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition ON, observe the scan tool APP sensor 1 voltage parameter. The reading should be between 0.32-4.75 volts, and change with accelerator pedal input.
- Ignition ON, observe the scan tool APP sensor 2 voltage parameter. The reading should be between 0.32-4.75 volts, and change with accelerator pedal input.
- Ignition ON, observe the scan tool APP sensor 1 and 2 parameter. The scan tool should indicate agree.
- Clear the DTCs with the scan tool. Operate the vehicle within the Conditions for Running the DTC, or within the conditions that you observed from the Freeze Frame/Failure Records.
- If DTC P2120 or P2125 are the only DTCs set, replace the control module.
- If DTC P0641 or P0651 are set, refer to DTC P0641 or P0651 (Set in ECM) .
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.