LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P1255 To DTC P3449) >> DTC P1516, P2101, P2119, or P2176 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Start the engine. Use a scan tool to observe the throttle position (TP) sensor 1 indicated position. Throttle position should increase as pedal is applied and decrease as pedal is released.
    2. IMPORTANT: A low voltage condition may set this DTC.
  2. Review the Freeze Frame/Failure Records and ensure sufficient ignition voltage was present when the DTC was set.
    • If voltage was low, verify with the owner that the battery was not discharged. If the battery has not been discharged, refer to Power Mode Mismatch .
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals