LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Hybrid Cooling System) >> Diagnostic Information and Procedures >> DTC P0A7E or P1ABE >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify that DTC P0A81, P0A9C, P0A9D, P0A9E, P0AC6, P0AC7, P0AC8, P0ACB, P0ACC, P0ACD, P0AE9, P0AEA, or P0AEB is not set.
  2. Ignition ON, observe the scan tool GBCM hybrid battery temperature parameters. The readings should be between -39 and +65°C (-40 and +149°F).
  3. Command the drive motor generator battery vent fan ON in all speed ranges with a scan tool. You should hear the vent fan relay softly click when turned ON and OFF. You should notice a change in fan speed as you increase the commanded speed. There is approximately a 5 second delay from when the battery vent fan speed is commanded before the vent fan speed changes.
scientia non olet · About LEMON Manuals