Conditions for Running the DTC (Set in ECM)

P0601

• The ignition switch is in Run or Crank.
• DTC P0601 runs continuously when the above condition is met.

P0602

• The ignition switch is in Run or Crank.
• DTC P0602 runs once per ignition cycle.

P0603

• The ignition switch is in Run or Crank.
• DTC P0603 runs once per ignition cycle.

P0604

• The ignition switch is in Run or Crank.
• DTC P0604 runs continuously when the above condition is met.

P0606

• The ignition switch is in the Unlock/Accessory, Run, or Crank positions.
• The system voltage is more than 5.23 volts.
• DTC P0606 runs continuously when the above conditions are met.

P0607

• The ignition switch is in Unlock, Accessory, Run or Crank.
• The system voltage is more than 5.23 volts.
• DTCs P0601, P0602, P0603, P0604, P0606, P062F, P0641, P0651, P2610 are not set
• DTC P0607 runs continuously when the above conditions are met.

P060D

• DTC P0606 is not set.
• The ignition switch is in the Unlock, Accessory, Run, or Crank position.
• The system voltage is more than 7.0 volts.
• DTC P060D runs continuously when the above conditions are met.

P062F

• The ignition is ON.
• DTC P062F runs once per ignition cycle.

P16F3

• The ignition is ON.
• DTC P16F3 runs continuously when the above condition is met.

P2610

• The ECM is powered down.
• The intake air temperature is between -40 to +125°C (-40 to +257°F).
• DTC P2610 runs once per ignition cycle.