LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P025A To DTC P0700) >> DTC P0442 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
IMPORTANT:
  • Refer to the J 41413-200  operation manual for detailed instructions in Evaporative Emission System Diagnosis .
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize.
  • Ensure that the underbody temperature of the vehicle and the tester are similar.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Connect the J 41413-200  to the vehicle at the EVAP service port. For vehicles without a service port, disconnect the purge tube at the quick connector on the EVAP canister side of the purge solenoid valve and install the CH-48096  .
  4. Using a scan tool close the EVAP canister vent valve to seal the EVAP system.
  5. Use the flow meter on the J 41413-200  , calibrated to 0.51 millimeter (0.020 inch) to determine that there is no leak in the EVAP system.
    • If a leak is detected, use the J 41413-200  to apply smoke to the EVAP system at the service port or the purge tube until the leak is located using the J 41413-SPT  .
scientia non olet · About LEMON Manuals