Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Clear the DTC.
- Operate the vehicle from 1st through 4th gear while observing the Direct 2-3-4 Clutch Slip parameter. Stop the vehicle and turn the ignition OFF for 30 seconds. Perform this action 2 times. The Direct 2-3-4 Clutch Slip parameter should display greater than 0 RPM when the Direct 2-3-4 Clutch Status parameter displays Released.
- If any other transmission DTCs are set, diagnose those first.
- If the DTC P07A5 resets, go to Component Testing.