LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Control System & Fuel - Hybrid (Hp2) 6.0L (LFA) - DTC P0010 To DTC P0232) >> DTC P0231, P0232, or P023F >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different variant/trim than selected.
  1. Ignition OFF, disconnect the harness connector at the fuel pump.
  2. Connect a test lamp between the control circuit terminal D and ground.
  3. Ignition ON, command the fuel pump ON and OFF using a scan tool ECM fuel pump output control. The test lamp should turn ON and OFF, as commanded.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the FPCM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the FPCM.
  4. Ignition OFF, connect a test lamp between the control circuit terminal A and the control circuit terminal D.
  5. Ignition ON, command the fuel pump ON using a scan tool. The test lamp should illuminate.
    • If the test lamp does not illuminate, test the control circuit terminal A for a short to voltage or an open/high resistance. If the circuit tests normal, replace the FPCM.
  6. If all circuits test normal, perform the Fuel System Diagnosis (w/o FPCM) or Fuel System Diagnosis (w/FPCM) to verify proper fuel pressure.
scientia non olet · About LEMON Manuals