P0171 or P0174
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
- Ignition ON, verify the scan tool hood position parameter displays Open.
- If the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Allow the engine to reach operating temperature. With the engine running, observe the affected Long Term FT parameter with a scan tool. The reading should be between 0-19 percent.
- If not within the specified range, inspect for the following:
- With the ignition ON and the engine OFF, observe the manifold absolute pressure (MAP) sensor parameter. The MAP sensor pressure should be within the range specified for your altitude. Refer to Altitude Versus Barometric Pressure
.
- Refer to DTC P0106 if the MAP sensor does not indicate the correct barometric pressure.
- With the engine idling, observe the mass air flow (MAF) sensor parameter. The MAF sensor parameter should be within 2-6 g/s at idle.
- Refer to DTC P0101 or P1101 or DTC P0102 or P0103 if the MAF sensor parameter is not within 2-6 g/s at idle.
- Vacuum hoses for splits, kinks, and improper connections
- Insufficient fuel in the tank
- Low fuel pressure-Refer to Fuel System Diagnosis (w/o FPCM) or Fuel System Diagnosis (w/FPCM) .
- Fuel contamination-Refer to Alcohol/Contaminants-in-Fuel Diagnosis (without Special Tool) or Alcohol/Contaminants-in-Fuel Diagnosis (with Special Tool) .
- Malfunctioning fuel injectors-Refer to Symptoms - Engine Exhaust .
- Missing, loose, or leaking exhaust components from the HO2S forward-Refer to Symptoms - Engine Exhaust .
- Vacuum leaks at the intake manifold, the throttle body, and the injector O-rings
- The air induction system and the air intake ducts for leaks or for a missing air filter element
- A cracked EVAP canister
- Evaporative pipes obstructed or leaking-Refer to Fuel Hose/Pipes Routing Diagram .
- The crankcase ventilation system for leaks
- The HO2S for improper installation and for electrical wires or connectors that may have contacted the exhaust system
- The HO2S signal circuit open, shorted to ground, or shorted to the low reference circuit
- Malfunctioning engine components-Refer to Symptoms - Engine Mechanical .