Conditions for Setting the DTC

P0153

• The ECM detects that the HO2S 1 rich-to-lean or lean-to-rich average response time is more than a calibrated value.
• DTC P0133 sets within 100 seconds when the above condition is met.

P0154

• The ECM detects that the HO2S 1 parameter is between 350-550 mV for 100 seconds.
• The Throttle Position (TP) Indicated Angle parameter changes more than 5 percent, 1 time.
• DTC P0154 sets within 100 seconds when the above conditions are met.

P0160

• The ECM detects that the HO2S 1 parameter is between 410-490 mV.
• The TP Indicated Angle parameter changes more than 5 percent 1 time.
• DTC P0160 sets within 100 seconds when the above conditions are met.

P1153

• The ECM detects that the HO2S 1 rich-to-lean counts, or the lean-to-rich counts are less than a calibrated value.
• DTC P1153 sets within 100 seconds when the above condition is met.

P2272

• The ECM detects that the affected HO2S is below 730 mV.
• DTC P2272 sets within 1 second when the above condition is met.

P2273

• The ECM detects that the affected HO2S is above 225 mV.
• DTC P2273 sets within 1 second when the above condition is met.