Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
- Ignition ON, verify the scan tool hood position parameter displays Open.
- If the hood position does not display Open, refer to Diagnostic Trouble Code (DTC) List - Vehicle for DTC P254F.
- Start the engine.
- Allow the engine to reach normal operating temperature.
- Allow the engine to idle.
- Observe the DTC information with a scan tool.
- If the scan tool indicates DTC P0016 has failed this ignition cycle, continue with the Circuit/System Testing.
- If the vehicle passes the Circuit/System Verification test, operate the vehicle within the Conditions For Running the DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records data list.