Conditions for Running the DTC

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

P182A, P182C, P182D, P182E

No engine torque signal DTC P2637.
The engine run time is greater than 5 seconds.
The engine torque is 55-450 N.m (41-332 lb ft).
The IMS indicates Park/Neutral for at least 1 second.

P182F

No output speed sensor (OSS) DTCs P0722 or P0723.
No engine torque signal DTC P2637.
Vehicle speed is greater than 16 km/h (10 mph).
The engine torque is greater than 50 N.m (37 lb ft).
The IMS indicates Park/Neutral for at least 1 second.
DTC P1826 has not passed during the current ignition cycle.
The gear ratio is within one of the following ranges:
- 3.33:1 to 3.50:1 for first gear
- 2.16:1 to 2.27:1 for second gear
- 1.56:1 to 1.64:1 for third gear
- 0.98:1 to 1.03:1 for fourth gear

P1915

The engine is cranking for more than 2.5 seconds.
The engine speed is greater than 500 RPM.
1st gear request for 7 minutes.