LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Fluid Cooler Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Oil Cooler Lines
    GM396804Courtesy of GENERAL MOTORS CORP.
  1. Install the transmission oil cooler lines to the vehicle.
    2. Fig 2: View Of Lower Shock Absorber Module Mount Bolts
    GM1761077Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not use air powered tools in order to disassemble or assemble any vehicle component. Bolt torques are vital to diagnosis. You can detect bolt torques only when using hand tools. Improper bolt torques can contribute to vehicle repair problems.
    CAUTION: Refer to Fastener Caution .
  2. Install the right shock rear mounting bolt on the lower control arm.

    Tighten:  Tighten the bolt to 50N.m (37 lb ft).

    3. Fig 3: View Of Right Differential Carrier Mounting Nuts & Washers
    GM1751768Courtesy of GENERAL MOTORS CORP.
  3. Install the right differential carrier mounting nuts and washers.

    Tighten:  Tighten the mounting nuts to 100N.m (75 lb ft).

  4. Install the cooling lines to the transmission. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
    5. Fig 4: View Of Transmission Cooler Hoses
    GM396817Courtesy of GENERAL MOTORS CORP.
  5. Install the engine protection shield. Refer to Engine Shield Replacement .
  6. Lower the vehicle.
  7. Install the transmission fluid cooler hose to the radiator. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  8. Install the transmission fluid cooler hose to the auxiliary oil cooler. Refer to Transmission Fluid Cooler Hose/Pipe Quick-Connect Fitting Disconnection and Connection .
  9. Install the front upper fascia support bracket. Refer to Front Upper Fascia Support Bracket Replacement .
  10. Install the front bumper fascia. Refer to Front Bumper Fascia Replacement (Yukon) or Front Bumper Fascia Replacement (Z71) or Front Bumper Fascia Replacement (Tahoe) or Front Bumper Fascia Replacement (Avalanche) or Front Bumper Fascia Replacement (Escalade) .
scientia non olet · About LEMON Manuals