LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Manual Shift Detent Lever with Shaft Position Switch Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the transmission oil pan and filter. Refer to Automatic Transmission Fluid and Filter Replacement .
    2. Fig 1: Identifying Manual Shift Detent Lever with Shaft Position Switch Assembly Components
    GM2035543Courtesy of GENERAL MOTORS CORP.
  2. Remove the following parts: (89), (92), (88), (85) and (84)
    3. Fig 2: Removing Manual Shaft Seal
    GM59273Courtesy of GENERAL MOTORS CORP.
  3. Remove the manual shaft seal (82) with a screwdriver.
scientia non olet · About LEMON Manuals