LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> 2-4 Servo >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Transmission Heat Shield Bolts & Shield
    GM394459Courtesy of GENERAL MOTORS CORP.
  1. Remove the catalytic converter pipe. Refer to Catalytic Converter Replacement .
  2. Remove the heat shield bolts.
  3. Remove the heat shield.
  4. Support the transmission.
  5. Remove the transmission crossmember. Refer to Transmission Support Crossmember Replacement (4WD 2500 Series) or Transmission Support Crossmember Replacement (4WD 1500 Series) or Transmission Support Crossmember Replacement (2WD 2500 Series) or Transmission Support Crossmember Replacement (2WD 1500 Series) .
  6. Lower the transmission with a suitable jack.
    7. Fig 2: Compressing The Servo Cover Using J 29714-A
    GM14478Courtesy of GENERAL MOTORS CORP.
  7. Remove the oil pan bolt below the servo.
  8. Install the J 29714-A  . See Special Tools .
  9. Tighten the bolt on J 29714-A  in order to compress the servo cover. See Special Tools .
    10. Fig 3: Removing The Servo Cover Ring
    GM642680Courtesy of GENERAL MOTORS CORP.
  10. Remove the servo cover ring.
  11. Remove the J 29714-A  . See Special Tools .
    12. Fig 4: Removing The Servo Cover And O-Ring Seal
    GM645364Courtesy of GENERAL MOTORS CORP.
  12. Remove the servo cover and O-ring seal. If the cover is hung up on the seal, use a pick (2) in order to pull and stretch the seal (1) out of the groove. Cut and remove the O-ring seal before removing the cover.
    13. Fig 5: View Of 2-4 Servo
    GM642523Courtesy of GENERAL MOTORS CORP.
  13. Remove the 2-4 servo.
  14. Inspect the 4th apply piston, 2-4 servo converter, 2nd apply piston, and the servo piston inner housing for the following defects:
    • Cracks
    • Scoring
    • Burrs and nicks
scientia non olet · About LEMON Manuals