Output Shaft Installation: Installation

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Output Shaft

Courtesy of GENERAL MOTORS CORP.

NOTE: It is important to note that the input shaft may need a light tap to fully seat into position. If the input shaft is not completely engaged, the output shaft to input carrier retainer (661) will not seat.

Install the output shaft (687).

Fig 2: Identifying Special Tool J29837-A & Output Shaft O-Ring Seal

Courtesy of GENERAL MOTORS CORP.

Install the J 29837-A: support fixture as shown. Support the output shaft (687) with adjustable stop (1).