Oil Pump Cover and Body Assemble: Assemble

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Pump Cover Bolts

Courtesy of GENERAL MOTORS CORP.

Place the oil pump cover onto the oil pump body and put stator shaft through a hole in the bench.
Install the pump cover bolts (233) finger tight only.

Fig 2: Identifying Pump Cover Bolts

Courtesy of GENERAL MOTORS CORP.

Install the J 21368: alignment band.

CAUTION: Refer to Fastener Caution .

Tighten the pump cover bolts (233). Tighten the bolts to 24 N.m (18 lb ft).
Remove the J 21368: alignment band.