Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Installation

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Parking Brake Pawl & Return Spring

Courtesy of GENERAL MOTORS CORP.

Install the parking lock bracket (86).

CAUTION: Refer to Fastener Caution .

Install the parking lock bracket bolt (87) and tighten to 31 N.m (23 lb ft).
Inspect the following items:
- The parking brake pawl (81) for damage or cracks
- The parking pawl return spring (80) for being broken or missing

Fig 2: Identifying Manual Shift Detent Lever with Shaft Position Switch Assembly Components

Courtesy of GENERAL MOTORS CORP.

Inspect the following items:
- Manual shaft (84) for damage or burrs
- Parking lock actuator assembly (85) for damage
- Manual shift detent lever with shaft position switch assembly (88) for damage or cracks
- Manual valve link (89) for damage
- Manual shift detent lever pin (92) discard, do not reuse
Install the following items:
- Manual shift detent lever with shaft position switch assembly (88)
- Parking lock actuator assembly (85)
- Manual shaft (84) (model dependent)
- NEW manual shift detent lever pin (92)
- Manual valve link (89)