Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressing Internal Speed Sensor Rotor Onto Output Shaft

Courtesy of GENERAL MOTORS CORP.

NOTE: Do not re-use an internal speed sensor rotor that has been removed.

Slip a new internal speed sensor rotor (699) over the output shaft splines.
Install the J 36352-4 which is part of J 36352: rotor installer kit in the groove on the output shaft (687).
Place the J 36352-6 which is part of J 36352: rotor installer kit on the output shaft (687). Press on the J 36352-6 until it contacts the J 36352-4 in the window (the J 36352-4 will be a positive stop for the J 36352-6 ).