3rd Accumulator Retainer with Ball Assembly Leak Check: Check

WARNING: This page is about a different car, the 2009 GMC Yukon and 2009 Chevrolet Tahoe. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of 2-4 Servo

Courtesy of GENERAL MOTORS CORP.

Install the 2-4 servo into the case.

Fig 2: Identifying J 29714-A

Courtesy of GENERAL MOTORS CORP.

Install oil pan with only four bolts to align pan to case.
Use the J 29714-A: depressor in order to compress the servo cover.
Install the servo cover retaining ring.

Fig 3: Locating Small Hole In Accumulator

Courtesy of GENERAL MOTORS CORP.

Remove oil pan.
Pour solvent into the accumulator bore until the channel is filled. Watch for leaks in the case channel.

NOTE: It is normal to see leakage from the small hole next to the larger oval hole.

If leakage from the oval shaped hole is observed, replace the third accumulator retainer and ball assembly.