Input Shaft Seal Replacement
WARNING: This page is about a different car, the 2009 GMC Yukon, 2009 Chevrolet Tahoe, 2009 Chevrolet Suburban, and 2009 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
|
CAUTION:
Do not damage the sealing surfaces of the transfer cases or the shafts when prying the seals for removal. Damaging the sealing surface may cause leakage or require replacement of the damaged component. Preliminary Procedures: Remove the transfer case. Refer to Transfer Case Assembly Replacement . |
|
| 1 | Transfer Case Nut Tip: Use transfer case nuts to secure transfer case to assembly fixture J 45759 . Special Tools: J 45759 Assembly Fixture |
| 2 | Transfer Case Tip: Insert the transfer case and assembly fixture into the bench holding fixture J 3289-20 and secure with pivot pin. Special Tools: J 3289-20 Holding Fixture |
| 3 | Transfer Case Input Shaft Seal Procedure
Special Tools: J 42738 Seal Installer |