Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Front

WARNING: This page is about a different car, the 2009 GMC Yukon, 2009 Chevrolet Tahoe, 2009 Chevrolet Suburban, and 2009 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Replacement - Front

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Ensure the bearing is installed squarely into the bearing bore.
1	Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly Tip: Ensure the printing on the bearing is facing upward. A suitable adapter is required to use with the J 8092: driver. Press the bearing until the bearing bottoms on the front case half. Special Tools J 2619-01: Slide Hammer J 8092: Universal Driver J 44737: Shift Rail Bearing Remover For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure:
Ensure the bearing is installed squarely into the bearing bore.

Transfer Case Four Wheel Drive Actuator Lever Shaft Bearing Assembly
Tip:

Ensure the printing on the bearing is facing upward.
A suitable adapter is required to use with the J 8092: driver.
Press the bearing until the bearing bottoms on the front case half.

Special Tools

J 2619-01: Slide Hammer
J 8092: Universal Driver
J 44737: Shift Rail Bearing Remover

For equivalent regional tools, refer to Special Tools .