Rear Output Shaft Assembly

WARNING: This page is about a different car, the 2009 GMC Yukon, 2009 Chevrolet Tahoe, 2009 Chevrolet Suburban, and 2009 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Output Shaft Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Front Output Shaft Drive Sprocket Spacer - Front
2	Transfer Case Four Wheel Drive Clutch Housing
3	Transfer Case Front Output Shaft Drive Sprocket
4	Transfer Case Four Wheel Drive Clutch Housing Retaining Ring
5	Transfer Case Front Output Shaft Drive Sprocket Spacer - Rear
6	Transfer Case Front Output Shaft Drive Sprocket Retaining Ring
7	Transfer Case Oil Pump Assembly
8	Transfer Case Rear Output Shaft Speed Reluctor Wheel
9	Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
10	Transfer Case Rear Output Shaft Rear Bearing Assembly Tip: Use an arbor press or suitable installer to install the bearing to the rear output shaft. Ensure the retaining ring groove in the outer race is positioned toward the rear.
11	Transfer Case Rear Output Shaft Rear Bearing Retaining Ring