Rear Output Shaft Bushing Replacement

WARNING: This page is about a different car, the 2009 GMC Yukon, 2009 Chevrolet Tahoe, 2009 Chevrolet Suburban, and 2009 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Output Shaft Bushing

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Ensure the bushing is installed squarely into the bushing bore.
1	Transfer Case Rear Output Shaft Bushing Tip: Press the bushing until the tool bottoms on the rear case half. Special Tools J 8092 Driver Handle DT-48022 Output Bushing Installer. See Special Tools . DT-48209 Bushing Remover. See Special Tools . For equivalent regional tools, refer to Special Tools .

Callout

Component Name

Preliminary Procedure:
Ensure the bushing is installed squarely into the bushing bore.

Transfer Case Rear Output Shaft Bushing
Tip: Press the bushing until the tool bottoms on the rear case half.

Special Tools

J 8092 Driver Handle
DT-48022 Output Bushing Installer. See Special Tools .
DT-48209 Bushing Remover. See Special Tools .

For equivalent regional tools, refer to Special Tools .