Front Output Shaft Drive Sprocket Bearing Replacement
WARNING: This page is about a different car, the 2009 GMC Yukon, 2009 Chevrolet Tahoe, 2009 Chevrolet Suburban, and 2009 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP.
| Callout |
Component Name |
|
Preliminary Procedure
- Using the J 35512:
bearing installer and an arbor press, remove the bearing assemblies from the drive sprocket.
- Ensure the bearings are installed squarely into the drive sprocket bore.
- Install the bearings from the top with the clutch teeth facing down.
|
| 1 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Front
Tip:
- Install the bearing using the long side of the DT-48211:
bearing installer.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211:
Drive Sprocket Bearing Installer
- J 8092:
Universal Driver
- J 35512:
Inner Pinion Bearing Installer
For equivalent regional tools, refer to Special Tools . |
| 2 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear
Tip:
- Install the bearing using the short side of the DT-48211:
bearing installer.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211:
Drive Sprocket Bearing Installer
- J 8092:
Universal Driver
- J 35512:
Inner Pinion Bearing Installer
|