LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2009 >> Escalade AWD V8-6.2L >> Repair and Diagnosis >> Transmission and Drivetrain >> Automatic Transmission/Transaxle >> Service and Repair >> Overhaul >> 4L60-E/4L65-E/4L70-E Automatic Transmission >> Assemble, Disassemble, and Installation >> Low and Reverse Clutch Piston Installation

Low and Reverse Clutch Piston Installation




Low and Reverse Clutch Piston Installation

Special Tools
* J 23327-1 - Forward Clutch Spring Compressor (Bridge)
* J 34627 - Snap Ring Remover and Installer
* J 36850 - Transjel Lubricant




1. Install the transmission (low and reverse clutch outer, center, inner) seals (696) on the low and reverse clutch piston (695).
2. Lubricate the seals with assembly lubricant J 36850 - transjel lubricant or an equivalent.




3. Install the low and reverse clutch piston (695) into the case. The notch in the piston must be aligned with the parking brake pawl window, in the case.




4. Install the low and reverse clutch spring assembly (694).

1. Using the J 23327-1 - compressor (bridge) , compress the low and reverse clutch spring assembly (694).
2. Using J 36850 - transjel lubricant install the low and reverse clutch retainer ring (693).

scientia non olet · About LEMON Manuals