Ambient Light Sensor: Service and Repair

Sunload and Twilight Sentinel Sensor Replacement

Removal Procedure





1. Remove the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement (Service and Repair) .
2. Pull the wire lead outward from the I/P carrier and disconnect the sensor.



Installation Procedure





1. Connect the electrical lead to the sunload and twilight sentinel sensor.
2. Route the wiring harness into the I/P carrier and position the I/P trim pad into place.
3. Install the I/P trim pad. Refer to Instrument Panel Trim Pad Replacement (Service and Repair) .