Driver Seat Head Restraint Speaker Replacement

Driver Seat Head Restraint Speaker Replacement

Removal Procedure





1. Insert a plastic flat-bladed tool at the base of the speaker grille and pry upward to disengage the retaining clips.




2. Remove the speaker grille from the seat.
3. Remove the screws which retain the speaker to the seat.
4. Route the speaker from the seat and disconnect the speaker harness lead.
5. Remove the speaker grille retainer.



Installation Procedure

1. Install the speaker grille retainer.
2. Connect the harness lead to the speaker route the speaker harness lead in the seat.

Notice: Refer to Fastener Notice (Fastener Notice) .

3. Install the 4 screws which retain the speaker to the seat.

Tighten the screws to 2.5 N.m (22 lb in).





4. Align the speaker grille to the seat.




5. Carefully push on the speaker grille to engage the retaining clips to the seat.