LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> XLR Base >> Repair and Diagnosis >> Transmission >> Hydraulic Diagrams >> Automatic Transmission - 6L50/6L80/6L90 - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis >> Repair Instructions - On Vehicle >> Transmission Control Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Shift Control Assembly And Nuts
    GM932160Courtesy of GENERAL MOTORS CORP.
  1. Install the shift control assembly (1) to the tunnel reinforcement.
    2. NOTE: Refer to Fastener Notice .
  2. Install the nuts securing the shift control assembly to the tunnel reinforcement.

    Tighten:  Tighten the nuts to 12 N.m (106 lb in).

  3. Connect the wiring harness connector to the shift lock control pigtail connector.
    4. Fig 2: Shift Lock Control Pigtail Connector & Wiring Harness Connector
    GM1275750Courtesy of GENERAL MOTORS CORP.
  4. Install the electrical connector (1) to the shift control assembly.
  5. Install the center console assembly. Refer to Console Replacement .
  6. Install the shift control trim plate. Refer to Console Trim Plate Replacement .
  7. Place the shifter in the NEUTRAL position.
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    9. Fig 3: Shift Control Cable Assembly
    GM932162Courtesy of GENERAL MOTORS CORP.
  9. Connect the shift lock control cable to the ball stud (3). Refer to Transmission Control Replacement .
  10. Install the floor panel tunnel panel reinforcement. Refer to Floor Panel Tunnel Panel Reinforcement Replacement .
  11. Install the intermediate exhaust pipe. Refer to Intermediate Pipe Replacement .
  12. With the shifter and the transmission in the NEUTRAL position, adjust the shifter cable. Refer to Shift Control Linkage Adjustment .
  13. Lower the vehicle.
scientia non olet · About LEMON Manuals