|
Preliminary Procedures
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle
.
- Remove the transmission fluid pan. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement .
- Remove the manual shaft detent assembly roller. Refer to Control Valve Lower Body and Upper Body Replacement .
|
| 1 |
Manual Shaft Detent Lever Hub Pin
Procedure:
Discard the pin. Replace with a NEW pin.
Tip:
"Walk" the pin out using side cutters. |
| 2 |
Manual Shift Shaft Pin
Procedure:
Discard the pin. Replace with NEW pin.
Tip:
"Walk" the pin out using side cutters. |
| 3 |
Manual Shift Shaft |
| 4 |
Manual Shift Shaft Seal Procedure
- The manual shaft must be removed to replace the manual shaft seal.
- Use the J 45201
to remove the seal from the transmission case. See Special Tools .
- Use the J 43909
to install the seal into the transmission case.
Special Tools
- J 45201
Cooler Line Seal Remover. See Special Tools .
- J 43909
Selector Shaft Seal Installer
|