Rear Window Panel Trim Replacement

Fig 1: View Of Rear Window Trim & Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Power operate folding top to down and stored position. Position driver and passenger seat fully forward. Remove roof bar tube assemblies. Refer to Roof Bar Tube Trim Replacement . Remove stowage trim from rear compartment panel. Refer to Body Rear Compartment Replacement . Remove lock pillar trim. Refer to Body Lock Pillar Trim Panel Replacement .
1	Rear Window Trim Panel Screw Tighten: 2.5 N.m (22 lb in) NOTE: Refer to Fastener Notice .
2	Body Lock Pillar Upper Trim Panel Nut Tighten: 10 N.m (89 lb in)
3	Rear Window Trim Panel Support Bracket
4	Rear Window Trim Panel Assembly Tip: Remove seat belt trim bezel from rear window. Leave bezel on seat belt Lift upwards to slide trim out from behind end of console. Route seat belts from both ends.