Manual Shift Shaft Position Switch Installation

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Manual Shift Shaft Position Switch Component View

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Manual Shift Shaft Position Switch Assembly
2	Manual Valve Link Tip: Align the switch activator slide with the manual valve link.
3	Bolt M5 x 55 Tip: Hand tighten only.
4	A/Trans Manual Shift Shaft Position Switch Harness Clip Tip: The wiring harness clip on the manual shift shaft position switch does not need to be replaced if damaged or missing. The clip functions only as a manufacturing assembly aid to keep the harness clear during an automated bolt installation process. If the clip is damaged, simply remove and discard.
5	A/Trans Manual Shift Shaft Position Switch Electrical Connector Tip: Connect and lock the manual shift shaft position switch electrical connector to the control solenoid valve assembly.