LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Transfer Case Adapter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Transfer Case Adapter, Bolts & Seal
    GM652614Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Always use a new seal for the adapter. Do not use any type of sealant or adhesive in place of or with the seal.
  1. Install a NEW seal onto the adapter.
    2. IMPORTANT: The transfer case adapter must be installed so that the adapter is evenly seated to the transmission before installing the retaining nuts.
  2. Install the adapter.
    3. NOTE: Refer to Fastener Notice .
  3. Install the adapter bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

  4. Install the transmission mount. Refer to Transmission Mount Replacement (4WD) or Transmission Mount Replacement (2WD) .
  5. Install the transfer case. Refer to Transfer Case Assembly Replacement .
scientia non olet · About LEMON Manuals