LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Engine Mechanical - 4.8L, 5.3L, 6.0L And 6.2L (3 Of 5)) >> Off-Vehicle Repair Instructions (1 Of 3) >> Engine Coolant Air Bleed Pipe and Hole Cover Removal (RPO L92)

Engine Coolant Air Bleed Pipe and Hole Cover Removal (RPO L92)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2007 GMC Yukon XL, 2007 GMC Yukon, 2007 Chevrolet Tahoe, 2007 Chevrolet Suburban, and 2007 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Coolant Air Bleed Pipe
    GM1401993Courtesy of GENERAL MOTORS CORP.
  1. Remove the engine coolant air bleed pipe bolts (309) from the first design engine.
  2. Remove the pipe (307) with seals (308).
    3. Fig 2: View Of Engine Coolant Air Bleed Cover Bolts
    GM1402001Courtesy of GENERAL MOTORS CORP.
  3. Remove the engine coolant air bleed cover bolts (312) from the first design engine.
  4. Remove the covers (313) with seals (308).
    5. Fig 3: View Of Engine Coolant Air Bleed Pipe
    GM1403313Courtesy of GENERAL MOTORS CORP.
  5. Remove the engine coolant air bleed pipe bolts (309) from the second design engine.
  6. Remove the pipe (307) with seals (308).
    7. Fig 4: View Of Coolant Air Bleed Cover Bolts
    GM1403314Courtesy of GENERAL MOTORS CORP.
  7. Remove the engine coolant air bleed cover bolts (312) from the second design engine.
  8. Remove the covers (313) with seals (308).
    9. Fig 5: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
  9. Remove the seals (308) from the pipe and covers.
  10. Discard the seals.
scientia non olet · About LEMON Manuals