1-2-3-4 and 3-5 Reverse Clutch Bearing Assembly Replacement
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
1-2-3-4 and 3-5 Reverse Clutch Bearing Assembly Replacement
| Callout | Component Name |
|---|---|
| 1 | 3-5 Reverse Clutch Bearing
CAUTION:
Install the NEW bearing assembly with the seal side up. Improper installation of the bearing may cause damage to the transmission.
CAUTION:
Do not use a hammer or other striking tool that may cause damage to the bearing and housing. Use care to ensure the bearing is installed slowly and evenly using an arbor press supporting the inner hub. Do not support by the housing or fracture will result.
CAUTION:
Do not reuse the bearing. Install a NEW bearing. Reusing an old bearing may cause damage to the transmission. Procedure Install the bearing flush to 0.3 mm (0.012 in) below the thrust surface. Special Tools
For equivalent regional tools, refer to Special Tools . |