LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 218 (Engine Mechanical - Hybrid (LZ1) - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Crankshaft Rear Oil Seal Housing Replacement >> Installation Procedure - Cover with Seal

Installation Procedure - Cover with Seal

WARNING: This page is about a different car, the 2011 GMC Yukon, 2011 Chevrolet Tahoe, and 2011 Cadillac Escalade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the J 41479-2A cone and bolts onto the rear of the crankshaft.
    2. Fig 1: Rear Housing Components
    GM2100848Courtesy of GENERAL MOTORS CORP.
  2. Install the NEW rear housing gasket (1), rear housing with seal (2), rear housing-to-engine bolts (3) and oil pan-to-rear housing bolts (4).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Tighten the rear housing-to-engine bolts (3) until snug. Do not overtighten.

    Tighten 

    Tighten the oil pan-to-rear housing bolts (4) to 12 N.m (106 lb in).

  4. Tighten the rear housing-to-engine bolts (3).

    Tighten 

    Tighten the bolts to 30 N.m (22 lb ft).

  5. Remove the J 41479-2A .
  6. Install the automatic transmission flexplate. Refer to Automatic Transmission Flex Plate Replacement .
scientia non olet · About LEMON Manuals