LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (3 Of 5) >> On-Vehicle Repair Instructions (2 Of 2) >> Automatic Transmission Flex Plate Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Engine Flywheel & Bolts
    GM832979Courtesy of GENERAL MOTORS CORP.
  1. Remove the automatic transmission. Refer to Transmission Replacement for the 4L60-E.
    2. IMPORTANT: Note the position and direction of the engine flywheel before removal.
  2. Remove the flywheel bolts.
  3. Remove the flywheel.
    4. Fig 2: View Of Bolts & Spacer
    GM642281Courtesy of GENERAL MOTORS CORP.
  4. Install two M11x1.5 mm bolts (1) to the threaded holes of the spacer, if applicable.
  5. Rotate the bolts clockwise to remove the spacer.
    6. Fig 3: View Of Rear Spacer
    GM642276Courtesy of GENERAL MOTORS CORP.
  6. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals