Installation Procedure

Fig 1: View Of Oil Pressure Sensor, Washer & Valve Lifter Oil Filter

Courtesy of GENERAL MOTORS CORP.

Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers .

NOTE: Refer to Fastener Notice .

If equipped with active fuel management perform the following step, using J 41712 or equivalent. See Special Tools . Install the oil pressure sensor (706) and washer (707).
Tighten: Tighten the sensor to 35 N.m (26 lb ft).

Fig 2: View Of Oil Pressure Sensor & Washer

Courtesy of GENERAL MOTORS CORP.

If not equipped with active fuel management, perform the following step, using J 41712 or equivalent. See Special Tools . Install the oil pressure sensor (706) and washer (707).

Fig 3: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp

Courtesy of GENERAL MOTORS CORP.

Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten: Tighten the sensor to 35 N.m (26 lb ft).
Install the intake manifold. Refer to Intake Manifold Replacement (RPOs LY2/LY6) or Intake Manifold Replacement (RPOs LC9/LMG/LY5/L76) or Intake Manifold Replacement (RPO L92 - First Design) or Intake Manifold Replacement (RPO L92 - Second Design) .