LEMON Manuals: Even more car manuals for everyone
Home >> Cadillac >> 2008 >> Escalade RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5) >> On-Vehicle Repair Instructions (1 Of 2) >> Engine Mount Replacement - Right Side (2500 w/RPO LY6) >> Removal Procedure

Removal Procedure

CAUTION:

When raising or supporting the engine for any reason, do not use a jack under any sheet metal, or the crankshaft pulley, or damage may occur.

  1. Remove the right engine mount bracket. Refer to Engine Mount Bracket Replacement - Right Side (2500 w/RPO LY6) .
    2. Fig 1: View Of Engine Mount To Engine Bolts
    GM1701900Courtesy of GENERAL MOTORS COMPANY
  2. Working through the wheelhouse opening, remove the engine mount to engine block bolts (1).
  3. Using the adjustable jack, raise the engine slightly until there is enough clearance to remove the engine mount.
    4. Fig 2: View Of Engine Mount
    GM1701903Courtesy of GENERAL MOTORS COMPANY
  4. Remove the engine mount through the rear of the wheel well opening.
scientia non olet · About LEMON Manuals